CommPlete's T1 Supported Parameters			6/24/99


T1 Line Type:
*  channelized T1 line with 24 DS0s

T1 Frame Formats:
1. DS1 AT&T Extended Super Frame (ESF - non-ANSI)
2. DS1 AT&T D4 format (SF)
3. DS1 ANSI Extended Super Frame (ESF - ANSI)
4. DS1 ITU-T  G.704  section 2.1.3.2
5. DS1 ITU-T  G.704  section 2.1.3.1

Line Coding Options:
1. B8ZS (Binary 8 Zero Substitution) ("Clear Channel")
2. AMI (Alternate Mark Inversion)
3. ZBTSI (Zero Byte Time Slot Interchange)
   (Note that "B8ZS without transcoders" is not supported)

FXS Signaling Options:
1. E&M Wink Start Conversion
2. E&M Immediate Start Conversion
3. Ground Start Standard
4. Loop Start Standard
   (Note that "DLY" (Delay) is not supported)

Dial-in Address:
1. No address
2. DNIS (Dialed Number Identification Service)
3. ANI-DNIS (Automatic Number Identification - 
     Dialed Number Identification Service)
4. ANI (Automatic Number Identification)

Trunk Pulsing:
1. DTMF
2. MF
   (Note that "Dial Pulse" (Pulse Dialing) is not supported) 

Acknowledgement Wink	
1.  Disabled

Transmit Level:		
1.  -0.0 dB
2.  -7.5 dB
3.  -15 dB
4.  -22.5 dB

DID (Direct Inward Dialing)
* No

Factory Defaults:  
T1 Frame Format:	ESF (DS1 AT&T Extended Super Frame)
Line Coding:		B8ZS (Binary 8 Zero Substitution)
FXS Signaling:		E&M Immediate Start
Dial-In Address:	No Address
Trunk Pulsing:		DTMF
Acknowledgement Wink:	Disabled